PDA

View Full Version : D offset cancel



barbter
08-05-2011, 06:17 AM
Hi Scott,
Ref the new feature of word address on the pointer.

We have ours set to display T# H# D#.
If tool 1 uses offset, then the address will show T1 H1 D1.
If next tool (say 2) doesn't, the address will show T2 H2 D1.

I assume the D value will only be updated when it is called again, but can you please look at cancelling at say tool change? That way if comp is not called on the following tool, a D0 is displayed instead.

Thanks

barbter
07-24-2012, 05:20 PM
Hi Scott,
I trust all is well.

Have you had chance to look at this please?
Specifically (for me :D), it would be good that when the next tool is called without a D value, the viewport value is blank ie

T2H2D

This would be prefereable to a D0.

Many thanks for the good work.
Cheers