PDA

View Full Version : 310 quickchange spindle nut disasssembly



garychipmaker
07-17-2011, 12:37 AM
Hi I can't figure out how to get the spindle nut apart on a # 30 quickchange spindle. The nut hits a stop before it is tight on the toolholder. I remove the 3 screws but how does it come apart is there a spring washer or such in there. If I leave the screws out it lets it turn farther to tighten. thanks for all the help

zpsbob
07-17-2011, 01:07 AM
Try putting to longer of the 3 screws in a different hole. It will tighten more

garychipmaker
07-17-2011, 02:27 PM
Thanks Its one of those things that are so simple after you know how it works I was trying to take it apart and never did figure what holds the nut from coming off after you take out the screws