PDA

View Full Version : RFQ: one off, ali, 80mm dia X 75mm long collar, 1/2" thru drilled, split



Bob Shaw
05-31-2011, 02:14 PM
Hi All,

Title says it all really. I need an 80mm diameter aluminium cylinder, 75mm long with a 1/2" drilled & reamed hole, slit along its length to act as a collar for a 1/2" tool.

Ideally you would be located in NC but I guess shipping's not going to be much of an issue from anywhere in the US.

Please respond to wilson@wilsonlogan.com

Thanks!

abcmojave
05-31-2011, 02:42 PM
Bob,

Do you have any Al type in mind? Tolerances? Slit width?

PMD
05-31-2011, 06:39 PM
Bob,

I sent you an email. Let me know if I can help you out.

-PMD

Bob Shaw
06-01-2011, 03:49 AM
Hi All,

+/- 0.5mm on diameter and +/- 2mm on length.

Obviously the reamed hole takes care of itself and the slit can be any convenient size.

Cheers,

Bob.

Bob Shaw
06-02-2011, 04:19 AM
Hi All,

I have accepted an offer from a forum member & this RFQ is now closed.

Thanks for your interest!