PDA

View Full Version : Newbie Need help wiring table controls



monolithfs
04-27-2011, 03:39 PM
I'm looking for some help getting my plasma/router table controls wired. It is a homemade plasma/router table. I saw the machine successfully cut material before it was broken down for transport, so I know everything to make it a full functioning machine is there. I currently can get the machine to travel on it's X, Y and Z axis but do not know where to connect the firing command control cable for the plasma torch itself. The plasma torch has a built in control cable port. I need to know how to identify the correct terminals to connect to.

I have clear picture of all component I can forward to any one that may be able to shed some light on my problem. Many thanks to anyone with a few minutes and information to share.

Kentuckyfarmer
04-27-2011, 08:05 PM
What brand plasma, what brand control, did you get the plasma with table?
Give as much info as possible and someone will help you out.