PDA

View Full Version : mach 2 wont run



pbmann123
08-23-2005, 12:05 AM
when i try and finish the end of the stup it says that it is unable to complete setup because i do not have windows nt 4.0 . i am running windows 98, which i thought would supercede but i was not sure, could you guys point me in the right direction of a free download, i am already overbudget on the cnc project...

kong
08-23-2005, 04:42 AM
Unfortunately you need either Windows XP or Windows 2000 to run the Machx software. You might want to try Master 5 from artsoft, but obvioulsy it is not nearly as good as Mach2. If you can, upgrade your version of windows. Sorry!
If you don't mind running DOS, you couldtry turbocnc from www.dakeng.com too.