PDA

View Full Version : RFQ: Flat Wood parts: 1/2" and 1/8"



nventian
04-12-2011, 08:36 PM
woodrfq

Hello,
I am looking to get an estimate for these wood parts (see attached PDF.)

Please quote the following:

Some parts are either hard ply or solid 1/2" wood stock (something harder than pine if solid stock)
Some parts are 1/8" birch ply (a nice smooth finish-quality ply)


Quantity:
Please estimate 10, 50, 100, and 500 count. (The contents of the PDF = 1 count.)

Timeframe:
There is no hard timeframe, this is a personal project of mine.

Materials:
I would like you to include a material estimate as a line item.

Production Method:
I don't know if 1/2" wood can be laser cut, or this is a routing job, or whatever. It doesn't matter to me as long as the final results are clean and accurate to 1/32"

Location:
Midwest preferred. I am located in Indiana.

Files:
The PDF file is attached. The password required to open the attached PDF is the first word of this post. I can provide the final files in any common vector format.

Contact:
Please email me at the address within the PDF document if the PM space on this forum is limited.

dpryor
04-13-2011, 08:13 AM
Your PDF document is password protected.

nventian
04-13-2011, 09:01 AM
Your PDF document is password protected.

I have found it to be a good way of weeding out those would-be vendors who can't even be bothered to take the time to read the first post.

Works every time.

WATERJET71
04-13-2011, 09:47 AM
woodrfq

Hello,
I am looking to get an estimate for these wood parts (see attached PDF.)

Please quote the following:

Some parts are either hard ply or solid 1/2" wood stock (something harder than pine if solid stock)
Some parts are 1/8" birch ply (a nice smooth finish-quality ply)


Quantity:
Please estimate 10, 50, 100, and 500 count. (The contents of the PDF = 1 count.)

Timeframe:
There is no hard timeframe, this is a personal project of mine.

Materials:
I would like you to include a material estimate as a line item.

Production Method:
I don't know if 1/2" wood can be laser cut, or this is a routing job, or whatever. It doesn't matter to me as long as the final results are clean and accurate to 1/32"

Location:
Midwest preferred. I am located in Indiana.

Files:
The PDF file is attached. The password required to open the attached PDF is the first word of this post. I can provide the final files in any common vector format.

Contact:
Please email me at the address within the PDF document if the PM space on this forum is limited.

Your drawings does not have any dimensions.

nventian
04-13-2011, 09:51 AM
Your drawings does not have any dimensions.

Parts are actual size in the PDF. Longest part is approx 7"

WATERJET71
04-13-2011, 12:00 PM
Good luck , nobody its going to give you a quote without dimensions if you give a dxf file that's a different story. That approximate doesnt fit when you are machining, that's only me I never give any prices if I dont have any dimensions.

nventian
04-13-2011, 12:20 PM
Good luck , nobody its going to give you a quote without dimensions if you give a dxf file that's a different story. That approximate doesnt fit when you are machining, that's only me I never give any prices if I dont have any dimensions.

Thank you. Dimensions have been added to the PDF and the PDF file has been updated.

Edit: ALL dimensions have been added.