PDA

View Full Version : Post Processor for Kitamura on Fanuc 15M



drpm
03-10-2011, 06:16 PM
Hi. Long time lurker, first time poster. Registered just to ask this question.

Just as the title says, I'm looking for a post processor for a Kitamura MyCenter HX300 with a Fanuc 15M control. I hear all Kitamuras are the same, if not extremely similar, so I think any Kitamura post processor should be ok.

Thanks

ProgSol
03-11-2011, 08:28 AM
I have one that may be of help to you if no one offers anything better. I'm not sure which Kitamura control it is for. I made it to program a job for someone and I just used a sample that they sent me to go by. If you want to try it email me at psi@fairpoint.net and I will send it to you.

Mike
Programming Solutions, Inc.

drpm
03-11-2011, 11:08 AM
Thank you Mike. Email has been sent. I'm willing to try anything and everything people are willing to offer.