PDA

View Full Version : Newbie Post processor Solidcam Mitsibushi M65i control



glenno7
03-01-2011, 02:40 PM
Hi, I'm looking for a post processor for Solidcam and Mitsibushi M65i control. Would a Fanuc processor work?

Brakeman Bob
03-02-2011, 02:50 AM
Fanuc would be close I think, but have a care around some of the addresses in canned cycles. For example, is the dwell address the same in G04 - Fanuc it is X0. whilst in (some) Mit's the address is P0. Something like that can cause a lot of damage in the wrong place

glenno7
03-02-2011, 02:26 PM
Thanks Bob, I will take your advice and have a close look.