PDA

View Full Version : Newbie need controller & electronics recommendations



RUTHLSSSCNC
02-07-2011, 05:48 PM
Hello all,
I am new to this forum, getting ready to build cnc plasma table similar to torchmate 2x4.
I have been looking at all the different controller's and electronics, and am not sure quite what to go with. If anyone could recommend any or tell me what ur experiences have been, It would be greatly appricated.
I am currently waiting on a quote from flashcut, but not sure if it is the best or reasonable.
Please give me input on what u think is best and worst.

RUTHLSSSCNC
02-07-2011, 06:32 PM
I mainly just need brand recommendations, not actual parts, I have that under control.
thanks