PDA

View Full Version : A axis set up



ACME
07-25-2005, 12:10 AM
hi, newbie question about "A" axis for rotory table...
my set up is Turbocnc(old ver.), PicoCNC and sherline rotary table(mm)

x,y,z no problem running with software and hardware, but "A" not work!!!

my question is, is it same set up .ini like other axis for turbocnc in "A" axis?

is it only way to use angle for spinning rotory table?

now, i can spinning it by keybroad"-" or "+", but out of control!! when i hit "+" it may go clockwise, sometime anticlockwise(motor sound not like other)....it drive me crazy, i give up......


need help