PDA

View Full Version : Problem 5 axis post processor



jjohnson2081
12-15-2010, 04:02 PM
Im running a parallel to curve command on a blade dovetail that requires 5 axis processing on a Haas VF3 trunniun. When I run simulation or verification on the computer the tool path is fine. When I run the code on the machine the primary rotary table is rotating a full circle near the center of the tool path. Is there a limit I can set to prevent these little circles?

dacar1
12-17-2010, 01:16 AM
Can you post the code?

jjohnson2081
12-17-2010, 01:29 PM
Yes I can post it out. The posted code is where I see the problem

dacar1
12-17-2010, 03:50 PM
I was trying to say that weather you can send the code so that we can take a look at it :)

jjohnson2081
12-17-2010, 04:17 PM
I'LL try to upload the file

solidcamx
04-18-2014, 09:49 AM
***https://www.youtube.com/watch?v=CGWZfzgMbVo****