PDA

View Full Version : Adding a new tool to the inventory



mwestvang
12-04-2010, 08:31 AM
I run RhinoCam Pro and have found the need to create a new tool that is not in inventory. Specifically a ground radius milling cutter so that I can cut an convex arc into the edge of a circle while mounted flat in the machine.

This is the tool I'm looking too use.

http://www.whitney-tool.com/html/convex_radius.html

Any ideas?

Mike

mwestvang
12-05-2010, 10:06 AM
Well it looks like a lollypop mill will do the job. Now I have it built in the inventory but can't get it to appear in 3 axis. Any suggestions?

Mike