PDA

View Full Version : DNC for drip feed



ramsey321
10-15-2010, 07:57 PM
Can anyone tell me if there is free DNC software that I can load on my PC to drip feed large programs to my J325 tree mill. Is there anyone out there that has drip feed to their J325 and if so what do you use. I have a Dynapath Delta 20 controller. Thanks

underthetire
10-15-2010, 08:24 PM
yes, and any program should work. I used to just use windows terminal. In the catalog page you type in RS232C, that starts a drip feed set up.

ramsey321
10-16-2010, 08:16 AM
Underthetire, can you please elaberate on this. I am not sure what you mean. Are you saying you use a windows program already on your pc or did you purchase this program. Thanks

Fastest1
10-16-2010, 08:34 AM
Yes it is called "Hyperterminal" I think. I have never used it but in pursuit of a dnc transfer solution I did read about it.

jagardner4
10-16-2010, 12:43 PM
There is a document online at the DynaPath website that describes how to use Hyperterminal to communicate with a DynaPath CNC:

http://www.dynapath.com/HyperTerminal.pdf