View Full Version : problem with z in sheetcam

10-02-2010, 07:59 AM
I am new to sheetcam.
I have imported a dwg and set up tools, choosen layers and so on. When i import gcode in mach3 all pieces of my drawing are spread from eachother on the z axis.
Is there some way i can align all lines to 0 on z in sheetcam?


10-02-2010, 08:45 AM
More detail:
If i use lazycam the pieces of my drawing are aligned on the z axis. But in sheetcam z jumps up and down like crazy. It also results in a very very long g-code. I just don't understand why lazycam can make a short code with z aligned while sheetcam can't...

Thanks in advance!