PDA

View Full Version : V5 5 Axis



Head Porter
07-10-2010, 11:36 AM
Hi everyone. I was woundering if there are any V5 5 axis users here that could give me some insite on how it works compared to MastercamX4. I have used MC for about 5 years and the shop I work for now uses Surfcam. I see some pretty neet features with Surfcam but it seems to be missing alot of the simplisty of Mastercam. Speed is everything in this world now and time is money.

Thanks for any imput.

Charlie

CNCRim
07-10-2010, 05:10 PM
I think you judge surfcam with few minutes use..... spend more time with this. Surfcam mill is very good, I would said it's better than MC, but lathe is opposite.