PDA

View Full Version : Help with cnc4pc C11 BOB



AVP
03-14-2010, 08:10 PM
Hello, In my current setup I am using the hobby cnc pro driver board and I have no complaints at all about its performance. I would however like to add some features, I decided to get the cnc4pc C11 BOB to add in between.

What I am asking is if anybody is using this BOB with a hobby cnc controller if they could provide any guidance as to configuring the board with mach3. As it is now it is hooked up but I cant get any signal to pass through the board on the parallel port. I do get leds to light when jogging but no signal.

Any advice would help.

Thanks
Bill