PDA

View Full Version : turbocnc and cams gcode



Lu_ca
04-22-2005, 06:47 PM
hi all, i have a trouble with turbocnc and the cam soft. I would like to use the demo of bobcad and deskcnc there are a post processor for these programs? Or there are a generic gcode that turbocnc can use.i read on nc in bobcad of fanuc centroid anilam, and in deskcnc in a generic isogcode (.dnc). My question is there are a method without make an interpreter to run this gcode on my turbocnc? Thanks a lot and sorry my confusion

jaypal
07-12-2006, 07:50 AM
hi lu ca , i too need the mastercam post for turbo cnc , if you able to find one pls forward it to me
jaypal@tessolve.com