programming Hurco vm20 with Alphacam

[ukprogrammer]

I have a Hurco vm20 that is programmed via conventional means, but i have a job that would benifit greatly from being programmed with a nc program through Alphacam. Has anyone done this through Alphacam and if so did you require a specific post for the machine or was there a standard one with alphacam that worked?
Thanks greatly

Similar Threads:

• programming hurco vm20 through alphacam
• HURCO VM20
• Hurco VM20 Winmax post?
• Need Help!- hurco vm20
• Hurco VM20 ???

[Hugo_Hans]

Hi
Alphacam has postprocesor for Hurco, I wrote it, but in alphacam default postprocessors you can't see it.

If you can send me some ALphacam file I can output it and I will send it back to you for check if it pass to your machine.

Regards
Pavel