- Need Help!- Alphacam Lathe face groove
-
Member
Alphacam Lathe face groove
I have alphacam 2021 , i need to make a face groove in 14 degrees angle and i have 2 issues
1- the tool is 14 degrees tilt so i need to get the tool path 14 deg. to avoid crash
2- the program does not take in consideration the material removed from the front of the part and until reaches the grove face material (.700 deep ) is cutting air
the part has a step of .700 deep and on the face of that step is the groove located
Similar Threads:
-
-
Member
Re: Alphacam Lathe face groove
As far as i can find out according to the technical service support there is no way to do the groove at an angle , i have a part with a grove on a 45 degree and this program can't make it hope they can fix that
On Mastercam you can select the angle of the tool path , i was told alphacam is one of the best and i have my doubts
- Need Help!- Alphacam Lathe face groove
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules