can alphacam take into account the tool holder when calculating the toolpath?

[Aburmaiz]

hello.
i have been working with alphacam for 7 years now.
i use it for stone carving mainly, recently i have been working on a big column capital and the tools doesn't reach as deep as they should to finish the roughing , so i added extensions but when doing the simulation it shows that the holder crashes into the stone.

any ideas?

thank you.

[Maroslav4]

hello.
i have been working with alphacam for 7 years now.
i use it for stone carving mainly, recently i have been working on a big column capital and the tools doesn't reach as deep as they should to finish the roughing , so i added extensions but when doing the simulation it shows that the holder crashes into the stone.

any ideas?

thank you.

Hi,

hard to say without a video or attached file.
Try upload your alphacam file.