Heads discusion


Results 1 to 3 of 3

Thread: Heads discusion

  1. #1
    Registered cncadmin's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    6855
    Downloads
    3
    Uploads
    4

    Default Heads discusion

    I'd like to get some input on the diffident head and heater design and links to where I can get them.

    Similar Threads:
    Thank You,
    Paul G

    Check out-
    [URL="http://www.signs101.com"]www.signs101.com[/URL]


  2. #2
    Registered
    Join Date
    Jun 2011
    Location
    United States
    Posts
    260
    Downloads
    0
    Uploads
    0

    Default

    The reprap wiki is always the place to start
    http://reprap.org/wiki/Category:Hot_End

    Generally those hotends using PTFE as a structural material are considered prone to failure. Most use Peek with a PTFE liner, but there are a number of newer hotend designs that use very thin stainless steel barrels and forgo both.

    In terms of pre made hotends, JHeads have a good rep, as do Buddaschnozzle's and the arcol hotends.



  3. #3
    Registered
    Join Date
    Jun 2011
    Location
    United States
    Posts
    260
    Downloads
    0
    Uploads
    0

    Default

    Double Post



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Heads discusion

Heads discusion