My Photo Gallery - Member Profile - Powered by PhotoPost

Welcome to the CNCzone.com-The Largest Machinist Community on the net! forums.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.

Home · Search · Register

Profile for davidmb
Number of photos	58
Number of comments	21
Number of times photos viewed	149,105
Disk space used	5.0mb
Last Photo Uploaded	cyclone separator
Last Comment Posted	finished spindle and mount on z axis Hi 9lrac9, It's a 1/2 HP motor, runs at about 16k rpm, to cut metal I would have to look at cooling/lubricant. I have tried to cut aluminium but only taken very shallow cuts 0.01" and the aluminium came off as very fine chips that were airborne ( that scared me a lot - wood dust is bad enough but aluminium! ). I will not try to machine metal again until I have built a full enclosure.

All times are GMT -5. The time now is 08:06 AM.