My Photo Gallery - Member Profile - Powered by PhotoPost

Welcome to the CNCzone.com-The Ultimate Machinist Community forums.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact contact us.

Home · Search · Register

Profile for metal_bender2
Number of photos	7
Number of comments	2
Number of times photos viewed	2,435
Disk space used	0.7mb
Last Photo Uploaded	Bridgeport retrofit control panel Geckos
Last Comment Posted	Bridgeport retrofit control panel Geckos Update, The gecko was found to have an intermittant. Thats the good news as I was a bit worried the existing superior motor would be a problem for the Gecko driver. For those who are thinking of retrofiting the electronics here's some of things I did to save cash. Reuse of lower right transformer as described in my other photos. Reuse of the terminal strip, power box moved to side of mill, reuse of 3 phase contactors and rewire of fwd/rev switch to directly drive contactors, reuse of caps (3) 5000uf + (1) 22000uf caps. I checked the caps to make sure they were'nt dried out. Nothing fancy just put 12v on and confirmed they would light a 12v car bulb... Good luck if your doing your retrofit. Kevin

All times are GMT -5. The time now is 08:21 PM.