| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Yeager Automation Discuss Ya controller software here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-27-2004, 06:55 AM
| |||
| |||
hooked up the motors and they all ran except the motors wouldn't run at low feedrates they would just jimmy back and forth and when I would jog or run a short program the machine doesn't always run in the right direction, if I tell it to go in the - direction it might keep going in the plus direction but then it would go in the - direction there was no set pattern. using a laptop with +5v from the usb port and running cncpro. Any suggestions? Running Camtronics control stepper motors Greg    |
|
#2
10-27-2004, 08:19 AM
| ||||
| ||||
| You may not have a good ground. Change you're acceleration settings as well, the accleration may be to fast, it it's not set right the steppers will not run right .
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4020 4th axis problems | little bubba | Fadal | 3 | 06-13-2005 10:08 PM |
| mystifying 320 problems | senor J. | Gecko Drives | 6 | 01-19-2005 08:40 PM |
| Problems running G-code | milgo | Mach Software (ArtSoft software) | 4 | 10-31-2004 11:27 AM |
| Tool Changer Problems | Snel | Haas Mills | 5 | 08-11-2004 09:56 AM |
| z axis direction question. | ljoe1969 | TurboCNC | 3 | 05-21-2004 09:53 PM |
| | |
Linear Mode
