| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Yeager Automation Discuss Ya controller software here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-26-2008, 06:35 AM
| |||
| |||
No matter what I put in to Ace for the Z offset and max Z pass values, the G code always comes out with a Z offset of 0.09448031 . What have I done wrong?? It had been working fine for years up until now.    |
|
#2
04-26-2008, 08:39 AM
| ||||
| ||||
| Not sure, but make sure the entities in your .dxf file are drawn at Z=0. If they are not drawn at Z=0. the offset from zero appears to get added to the final depth.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What RPM/Depth of cut? | sp1nm0nkey | General Metal Working Machines | 4 | 04-07-2007 11:45 PM |
| problem with depth in v carve | timmyb199 | Vectric | 7 | 11-01-2006 12:42 AM |
| Problem with drill depth | Alan S | Post Processors for MC | 2 | 11-03-2005 03:23 AM |
| Npt Depth | ryanduc | General Metalwork Discussion | 5 | 06-23-2005 05:24 PM |
| rotary 4 ax depth of cut q. | nervis1 | Mastercam | 4 | 03-24-2005 05:34 PM |
| | |
Linear Mode
