Other thread got closed , maybe start on here
looks very good george. Looks like you have everything worked out now.
Will be sending you a pm shortly.
i am looking into getting a open forum set up on my site, so hopefully will have it set up soon and also the site ,
Last edited by CNCadmin; 03-13-2013 at 11:45 PM.
Sorry your thread got closed George. It seemed to me every other page was you telling about some new item you were carrying or using or going to start selling etc. I guess you were scaring the other vendors with new products??
I cant wait to get my HiWIN square rail machine from you!!!
Yes Thanks , maybe i don't know why it really got closed, i don't see anything different from my thread to every other thread on that forum , and some one put me in that forum to begin with , all i can say if their worried all ready they have not seen everything yet , i want to make so everyone can afford a machine , big or small one, with out pay 10x extra for a machine
i think they should move the thread rather than close it. i know its tricky for them cause its half technical, half advertising.
i tried surfacing my steel table last night, and the thing bowed 1/8". so, tip: dont use cold rolled steel for a table, it has too much internal stress.
i tried surfacing my steel table last night, and the thing bowed 1/8". so, tip: dont use cold rolled steel for a table, it has too much internal stress
What are you going to use instead of cold rolled steel. I'll be facing the same problem soon. Not sure what to use. The aluminum table from George is about $800 ( a tad too much for now)
you can use it, you just have to split it up into panels first then surface each piece individually.