Been unable to work in the shop due to a bad virus. Finally got out there yesterday and took today off from work
Got the main XYZ Gantry kit pieces in place.
I created some supports out of 8040 extrusion so I could move the supplied cross beams around to see about getting some room for the rotary axis.
The way it is set at the moment will allow for reaching a stock with width of about 16 inches. This leaves about 33 inches or so for the XY cutting plane along the X axis. The table could hang over a couple of inches on the rotary end though. Still pondering those positions.
This pretty much ends all the 'quick' stuff. Now it's time to figure out what I need for the control box and it's configuration and order parts.
There's still plenty of putzing I can do though, and that's more fun
BobL.