Newbie Skipping steps on the taig - CNCzone.com-The Largest Machinist Community on the net!

08-09-2009, 06:18 AM

nurp

Join Date: Dec 2006

Location: USA

Posts: 11

Skipping steps on the taig

permalink

I have a Taig mill that when running a test piece it is skipping or loosing steps. This happens more when feed is in x and y at the same time. I can jog them at 20 ipm and it does not skip, only when in cycle. I am running the Mach 3. When feeding a 5 ipm the y axis makes some jumping sounds. I have the 3-axis kit on the Taig mill all is new.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Taig CNC loosing steps again	diamondback21	Taig Mills & Lathes	6	05-25-2009 01:21 AM
Stepper Skipping Steps	skartch	General Electronics Discussion	2	10-27-2008 05:27 PM
Skipping Line Code???	bvweld	DynaTorch	1	09-24-2008 12:16 AM
Taig Micro Mill 2000 steps per unit	JV11	Linear and Rotary Motion	4	09-26-2006 07:13 AM
Taig MicroMill 2000 and Mach 2, Steps/Unit??	JV11	Mach Software (ArtSoft software)	2	09-25-2006 09:32 PM

All times are GMT -5. The time now is 12:35 PM.