| | |
Need help soon! Purchased a Xylotex 3 axis board and 3 - 269oz steppers 6 months ago. Worked perfect first try but recently I reformatted my pc and I have not been able to get it to work off of Mach3 again. I have since tried 2 other computers and still no luck. I just noticed that the board's red LED does not light up (the fan still runs though). Hoping you guys have some suggestions as this is a school project that needs to be up and running soon for graduation! Thanks in advance for your help!
BRYAN
Contact Xylotex support if the light isn't coming on.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
| | |
LinkBack URL
About LinkBacks
