| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Xylotex Discuss all Xylotex drivers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
07-20-2004, 08:21 AM
| ||||
| ||||
| Are your switches N.O. or N.C. ? If N.C., I think it should be active low. Not 100% sure, though.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What encoders to use for these motors? | Cold Fusion | Servo Motors and Drives | 9 | 06-02-2005 11:14 PM |
| Does anyone know of a controller board for synchronized stepper motors | Yellowbeard | Stepper Motors and Drives | 2 | 04-03-2005 11:06 PM |
| Looking for controller board for synchronized stepper motors | Yellowbeard | General Electronics Discussion | 0 | 04-02-2005 08:50 AM |
| Stepper Motors | kellogs72 | Stepper Motors and Drives | 1 | 11-29-2004 07:27 PM |
| What to use for wiring stepper motors? | CNC Darren | General Electronics Discussion | 8 | 11-01-2004 11:40 PM |
| | |
Linear Mode
