Check the yahoo group. He said he's been replying to you.
I've been trying to contact xylotex for about a week. I finally got one axis of my board working but (long story) a bit later it just stopped working. I now think one of my motors was bad OR the board blew the motor. Regardless I cant really blame xylotex BUT
Ive emailed him three times, left messages on four groups and now here and no response. I wanted to either send it to him to repair or just buy a new board if my motor had toasted the board (the board still ohms correctly on all 3 axes but when i hook up 1 or more steppers they dont lock up and one just "twitches" the other two do nothing)
Any help? Or can someone suggest another 2.5a or more bipolar chopper driver for < $200?
Thanks a lot for your help
Charles
PS does anyone have a link to a good cheap plastic case supplier? I had an incredible one but lost the link.
Similar Threads:
Check the yahoo group. He said he's been replying to you.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Finally got his email. Apparently they were getting lost in translation. To anyone who gets the wrrong idea i like the xylotex board a lot. Unless your willing t o spend almost 3 times as much for gecko boards you cant get better period. Its just very frustrating being unable to communicate