Try asking your question in this forum:
So first 1000 sorry to post this subject maybe at the wrong place (and sorry for my english...)
So I am french and that done pufff 1 year I buy a CNC on ebay
FOR WHAT IS DONE THIS CNC
This CNC is for done ANTHILL (yes that is strange)
but look at this picture and you will understand why a CNC could be very interesting to realise ANTHILL in quantity
ANTHILL can be in "YTONG" (Beton cellulaire in french but don t know the word in english) in YEAST, WOOD... (it depends of the ant species)
THE CNC PROBLEM
So to This CNC come from from US (110 V) so I have to converse it to 220 V (so that is done)
- THE STEPPER DRIVER
This CNC have a Xylotex control card (XS-3525/8S-3) and that is my big problem because I have well the PDF of this card but I have lot of problems to understand it
For the moment the electronic is like that
- THE MOTORS
DC 6 V
WHAT I NEED LIKE HELP
Well I will need help to know if motors are good and to know what I have to do before connect motors
Actually I don t understand the manual user (PDF) so if somebody can explain me what I don t understand and what is important in the manual
Well I think it is a good start
THANKS A LOT !!
Last edited by fourmi; 05-11-2007 at 06:56 PM.
Hum somebody to help me to configure the CNC (motors and card)
What VREF I have to put for this motors of 6 V DV ?
I will do my best to help.
What is the Amps/phase of your motors?
You need this to set the VREF.
I have done a google for your motors and they are rated 1.2Amps/phase unipolar.
If you are going to run them bipolar series the VREF needs to be set to 1.2Volts.
1.2 Amps times 0.7 times 1.44 = 1.2V
Ah thanks (sorry for the late) !!!
Thanks a lot because I am really lose with CNC technics words and the english the mix is too for me
Well I think alone I will never found the right VREF lol
Hum Bipolar unipolar ? I have a choice to do ?If you are going to run them bipolar series the VREF needs to be set to 1.2Volts.
Have you a test to verify motors are ok ?
In the PDF they speak of "jumper" so how to configure them ? How dispose them ? And they are done for what ?
Thanks a lot Oldmanandhistoy