| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Xylotex Discuss all Xylotex drivers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
03-17-2004, 08:10 AM
| ||||
| ||||
Jeff I do not have access to the forum anymore, it says members only, yet my email address is shown after the "Welcome" on the top line. How do I get access again? The mechinical portion of my CNC is finally finished and now need to hook up the electronics. Hager    |
|
#2
03-18-2004, 08:31 AM
| ||||
| ||||
| Hager - try it this a way: http://www.cnczone.com/forums/forumd...?s=&forumid=82  JimBTW this message shows in the Xylotex forum ? are you there?
__________________ Experience is the BEST Teacher. Is that why it usually arrives in a shower of sparks, flash of light, loud bang, a cloud of smoke, AND -- a BILL to pay? You usually get it -- just after you need it. |
|
#4
03-18-2004, 11:04 AM
| ||||
| ||||
| DOOOOH!
__________________ Experience is the BEST Teacher. Is that why it usually arrives in a shower of sparks, flash of light, loud bang, a cloud of smoke, AND -- a BILL to pay? You usually get it -- just after you need it. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with limit switches and Xylotex board | dowling177 | Xylotex | 5 | 11-26-2008 03:51 PM |
| O/T How many forum members does it take... | Rekd | CNCzone Club House | 31 | 02-23-2008 01:03 PM |
| OneCNC Support Forum | OneCNC | OneCNC | 4 | 06-26-2007 11:38 AM |
| Mach2 and its Yahoo forum. | ynneb | Mach Software (ArtSoft software) | 30 | 03-29-2005 07:18 PM |
| I'm Lost & Frustrated - Need Help | Hack | Stepper Motors and Drives | 14 | 12-09-2004 04:45 PM |
| | |
Linear Mode
