| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Xylotex Discuss all Xylotex drivers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-22-2006, 09:51 PM
| |||
| |||
can someone link me to some installation sheets for the old xylotex drivers. I have a single and a three axis board from late 03 i guess. my 1st gen deskcnc controller went out and im trying to reinstall the new 2nd gen board, but it seems that the old deskcnc board provided power to the xylotex drivers. im trying to figure out how it was hooked up, but the old xylotex are poorly labeled and and im not sure if the 5v on the deskcnc were ins or outs. anyway little help would be appreciated.  |
|
#2
10-23-2006, 05:08 AM
| ||||
| ||||
| Files section of the Xylotex Yahoo Group.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
