| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Xylotex Discuss all Xylotex drivers here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-31-2005, 05:33 PM
| |||
| |||
Hello.. I'm using turbocnc to run the board running a lathe. When I first set it up the only way I could get the motors to run was, the z axis stepper wires were attatched to the TPY connectors. and the X asis was setup on the TPX ports as they should. I believe that the TPY chip is going bad because it intermittantly just stops working. (yes I have fans cooling the heatsinks). I've never had any problems out of the Z axis at all. My question is- Is it possible to put my X axis stepper wires on the TPZ connectors and have TURBOCNC be able to export the x axis commnads to the right pins on the LPT port??    |
|
#2
12-31-2005, 05:34 PM
| ||||
| ||||
| Yeas, just change the pins in TurboCNC for that axis.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
