New Cnc Router - CNCzone.com-The Largest Machinist Community on the net!

sintratech · #1 02-04-2007, 04:12 PM

I just bought a new router and purchased the electronics its all up and running. My question is my router came with a MDF 3/4 solid board its cutting area of the machine is 16x17" am I going to need to go with a T slot table to clamp my parts down? I dont want to go with a vacuum cause my air compressor is too loud and I dont cut hours at a time.

6105Moss · #2 05-29-2007, 11:16 PM

How about a good shop-vac and some small diameter thru holes,
if needed try some window screen rubber intalled in milled o-ring
groove.

samcrow · #3 05-29-2007, 11:20 PM

how much vac uum is required for a table this size?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using a router for the 1st time. Need advice of cut speeds, router bits etc.	Apples	DIY-CNC Router Table Machines	19	09-23-2006 04:33 PM
Surfcam PP for Isel router / Precix router	IvanTochev	Post Processor Files	2	05-12-2004 01:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)