small size router bits

[gtoutounji]

Hello,

Where can I find small sizes router bits for cnc wood carving? I need 1/32" cutting diameter and smaller.

Thanks,
Ghazi

[ger21]

http://www.precisebits.com/

[gtoutounji]

Thanks Gerry.

Ghazi

[cuemaker1]

www.cuestik.com

[gtoutounji]

Thanks.

Ghazi

[jimlas53]

Ghazi,
Check out Microcut (www.microcutusa.com) they have a good selection of bits. They sell through local distributors. I usually order and receive the cutters in the same week. I use them on all my machines. I use .0312, .0625, .125 carbide mills, both ball-end and flat for 90% of my work and they last a long time. The biggest problem I have is breakage (mostly due to operator error) especially in the smallest sizes. I make 1/12-scale tractor parts in Maple and Cherry, and these are small parts.
I made tool holders .500 diameter to fit my Porter-Cable routers. They hold a .125 diameter cutter shank.
The ball-end cutters do a great job when doing 3D toolpath cutting.

Hope this helps!

Doug
www.woodntractors.com

[gtoutounji]

Thanks a lot Doug. I will check if they have distributors in Canada.

Ghazi

[pike88]

www.routerbits.com

[woodman08]

try tate industrial windsor ont 1 800 265 3814 tell them stan from kincardine send you