What type of bit would you use to cut 3/4" MDF with a formica laminate on top?
And what feed and speed?
I assume a down cut so as not to peel up the formica.
I normally cut aluminum but a friend has a project for me.
Either a downcut or a compression spiral. For a 1/2" tool, 600-700ipm @ 16,000 rpm.
You could also use a cheap carbide tipped straight bit, at a much slower feedrate.
Mach3 2010 Screenset
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)