| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| WoodWorking Discuss wood working techniques and tips here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-23-2005, 06:50 PM
| |||
| |||
| Fretwork router bits Hey gang. Was looking at some patterns of Fretwork, but i am confused on what type or size of bit to use. Some of the corners and curves are so tight that a 1/8" size bit would round out. I am looking at scrollsaw patterns, but is there a way to replicate the fine cuts on a DIY CNC Router?    |
|
#2
09-23-2005, 10:17 PM
| ||||
| ||||
| Try here. http://www.precisebits.com/
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
