need wincnc.ini file for practicalcnc table

[bhw]

I reinstalled wincnc and lost the proper ini file. Anyone have a stepper table from practical cnc? I'm not having much luck hearing back from them(precisionae). It's a 5 by 10 table with athc I got about 4 years ago. Any help would be great, thanks.

[Switcher]

You might ask cabnet636 (member here on cnczone), I think he works with wincnc.

The link below will take you to his PM (private message) page.

http://www.cnczone.com/forums/privat...=newpm&u=79066


.

[cabnet636]

i sent him my contact info and got no response, practical cnc was not exactly on top of the pole and i would not expect a name change to solve that.



jim

[Torchhead]

I reinstalled wincnc and lost the proper ini file. Anyone have a stepper table from practical cnc? I'm not having much luck hearing back from them(precisionae). It's a 5 by 10 table with athc I got about 4 years ago. Any help would be great, thanks.

The WINCNC has no settings for the THC part. Everything else is the pins and motor tuning. Contact me offlist. I have notes from some WINCNC INI setup files for where we helped customers retro to a THC that actually works. I can get you in the ballpark with all of the correct pin settings and some motor tuning numbers. You may need to tweek the steps per unit calibration some to get exact.

TOM CAUDLE
www.CandCNC.com

[santiago lisboa]

Hi
I am triying to connect a touch probe to my table. I need the wincnc.ini instructions to enable a probe to manual scan.

And any other instruction tahs may help me to be abla to do manual scan with wincnc.

Thanks,