Need Help! Okuma Steady rest - CNCzone.com-The Largest Machinist Community on the net!

641mikeh · #1 06-05-2009, 02:49 PM

Looking for a hydraulic steady rest that will fit on an Okuma LU45 VDI turret.

MCR-B II · #2 10-07-2009, 10:06 AM

hi

If you want hydraulic steady rest controlled by manual and m code you need retrofit on tailstock slide way fixing.

Okuma uses SMW steady rests.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
puma 250 steady rest	bala955	Daewoo/Doosan	0	01-19-2009 09:30 PM
Need Help!- Mori Seiki Steady Rest	mike9696	Mori lathes	5	09-20-2008 11:48 PM
AUXILLARY STEADY REST FOR PATRIOT	smallblock	Shopmaster/Shoptask	0	04-17-2008 10:50 AM
TL-2 Steady rest	rbest27	Haas Lathes	10	04-17-2008 07:15 AM
Open Steady rest	Loelco	General Metalwork Discussion	1	02-07-2008 05:29 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)