Results 1 to 2 of 2

Thread: CNC Driver Board Suggestions

  1. 03-18-2009, 11:58 PM #1
    greg3000
    greg3000 is offline
    Registered
    Join Date
    Dec 2007
    Location
    USA
    Posts
    4
    Downloads
    0
    Uploads
    0

    CNC Driver Board Suggestions

    Can anyone tell me where I can find a good CNC driver board? I purchased a kit but it did not have a CNC driver board included. It did have 3 NEMA 23 stepper motors (4 wire, 113 oz inch).

    Regards,
    Gre

  3. 03-19-2009, 12:53 AM #2
    port_huon
    port_huon is offline
    Registered port_huon's Avatar
    Join Date
    Dec 2007
    Location
    Australia
    Posts
    348
    Downloads
    0
    Uploads
    0
    It's hard to go past Geckos. All depends on requirements/budget.
    Regards
    Geoff

« parts? | Manual needed »

Similar Threads

  1. Backer board and pressure/vac foot suggestions?
    By ecotectoo in forum General Metalwork Discussion
    Replies: 0
    Last Post: 06-17-2008, 06:39 PM
  2. driver board suggestions
    By pjpj410 in forum Stepper Motors and Drives
    Replies: 4
    Last Post: 03-31-2008, 04:48 PM
  3. breakout board suggestions for mach and lathe
    By panaceabea in forum Mach Lathe
    Replies: 4
    Last Post: 12-15-2007, 04:20 PM
  4. single axis driver and a b.o.b.,or multi-axis driver board
    By .xXACEXx. in forum Stepper Motors and Drives
    Replies: 3
    Last Post: 07-03-2007, 12:13 AM
  5. driver board
    By mtaddei in forum Benchtop Machines
    Replies: 1
    Last Post: 11-19-2004, 03:13 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.