LinkBack URL
About LinkBacks
Mr HuFlungDung here
Try Sterling Instrument. Their website is down at present, but not for good, I hope.
| | |
Greetings!
Mr Yeagle here
currently a technology education (shop ) teacher near philly, USA...
My students are about to construct 1/24 scale slot cars.. in the past I have purchased (at a good cost) plastic "crown gears"
my supplier has dried up..
I am now in search of a new solution.. someone out there has to make an extrusion something like this
http://members.optusnet.com.au/bpatto/parts/SIGS03.gif
looking for an extrusion with a spur gear type profile that is approx .75 inch outside dia..
anyhelp??
mryeagle@gmail.com
Mr HuFlungDung here
Try Sterling Instrument. Their website is down at present, but not for good, I hope.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
http://www1.mscdirect.com/CGI/GSDRVS...00000073520631
Might be of use - less than 3 bucks each and they have nearly 50 in stock?
I've been looking for some larger and happened on MSC as an option.
If metal is OK - how about McMaster - for gear stock - cut your own to length?
Stock Drive site ( http://www.sdp-si.com/ ) is down tooBUT, they do carry spur gear stock.
Jim
Experience is the BEST Teacher. Is that why it usually arrives in a shower of sparks, flash of light, loud bang, a cloud of smoke, AND -- a BILL to pay? You usually get it -- just after you need it.
Posting Permissions
| | |
