| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Want To Buy...Need help! Post items that you are looking for so people can help you to find where to buy them. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-17-2008, 01:44 PM
| |||
| |||
Would like to stretch the bed on my little Taiwanese router. Any source for longer rails and ball screws? Advice on pulling it off? Was intending to fab a new base, add vac table and a longer screw and rails. Anything to watch out for? Anyone done the same? Thanks guys.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| XY table design basics, linear ways to table size ratio? | Konstantin | Mechanical Calculations/Engineering Design | 0 | 03-13-2007 01:21 PM |
| Extending RS232 over long distances | jderou | General Electronics Discussion | 26 | 11-04-2006 07:23 AM |
| Extending text to a surface? | lotsa luck | BobCad-Cam | 2 | 02-24-2005 08:21 AM |
| Extending toolpath entry and exit points? | microdot | GibbsCAM | 0 | 08-25-2004 04:06 PM |
| extending THK rails, rail alignment | Cliff_J | DIY-CNC Router Table Machines | 1 | 05-28-2004 01:09 PM |
| | |
Linear Mode
