Fadal 32MP Control - CNCzone.com-The Largest Machinist Community on the net!

bigcrunch · #1 02-13-2008, 11:29 AM

Hi, I have been shopping for a CNC machine, probably Fadal 4020.
Most have Fadal 32MP Control are they good, bad, easy to use,,, ???
thanks,
Tom

DareBee · #2 02-13-2008, 01:31 PM

They are proven and reliable.
IMO not as fast as they should be, and look ahead is poor.

You will find a lot of places running the 88HS control, the 32MP is a computer networked to the 88HS in 1 panel.

bigcrunch · #3 02-13-2008, 02:46 PM

Is 5000 spindle hours high for a Fadal 4020?
Probably a vague question being a used machine, but hey any input I can get I would appreciate in making the right decision.
thanks,
Tom

bigcrunch · #4 02-13-2008, 02:47 PM

Is 5000 spindle hours high for a 2000 Fadal 4020?
Probably a vague question being a used machine, but hey any input I can get I would appreciate in making the right decision.
thanks,
Tom

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Programing fadal 88 control	Keith Reevie	Fadal	5	05-23-2011 08:18 AM
FADAL 32MP RS-422 Pin Config.	komplekx	Fadal	6	10-23-2006 01:07 PM
Fadal 18I Fanuc Control bug	chipsahoy	Fadal	2	02-12-2006 09:11 AM
Fadal with Fanuc control??	REVCAM_Bob	Fadal	1	10-01-2005 11:34 AM
older fadal control ?	tractdesign	Fadal	11	01-08-2005 03:26 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)