I'm bought a DIY kit, it's 48 x 24 x 5 on the z. I know how to wire the step motors and controller, but can't seem to figure out how to route my wires so they're not all messy. i've looked at the cable track from the links here and wonder if that's the only way to do it. so, if i decide to use cable track....can i route my router 110 cord with the 24 volt lines? or do you guys mount it from above some way? i 've never did this before and any input on the matter would really be helpful too....thanks you also.
I have all my cables in the E chain