Here are the dimensions: http://www.speedyshare.com/files/24329731/knob.pdf
Tollerance within reasonable limits ain't that important. +/- 0.25mm or so.
The only important tollerance is on the 6.4mm. + 0.25mm - 0.00mm
Height is not shown in the drawing, but is 10mm!
Last edited by ChrioN; 09-20-2010 at 06:24 AM. Reason: Added PDF file
New dimensions in first post
Last edited by ChrioN; 09-20-2010 at 06:49 AM.
You probably need one more dimension....either the angle of the outside bevel or the width of the surface at the top.
You should probably add some tolerances.
Paul
I've added a PDF drawing with all dimensions. I forgot to add the height of the part: its 10mm
Last edited by ChrioN; 09-20-2010 at 06:49 AM.
how many do you want made and what type of aluminium?
Quantity depends on quality. A couple of hundred if the quality is good.
My knowledge in different types of aluminum is limited.
It doesn't have to be an exotic type, but something thats not too soft (might make tollerances harder to keep?).
Also, would like the sides (not the angle) to be knurled.
That requires a certain quality of aluminum I guess.
Originally Posted by jjones12
Last edited by ChrioN; 09-20-2010 at 07:57 AM.
PM sent.
Regards
Colin
BEWARE!!! I got a virus this AM, and I suspect it came through speedyshare. Anyone else had a problem since looking at that file?
speedyshare is legit. I would never put up a link to a virus infected download site.
OK. No offense intended, just that it popped up shortly after I looked at it. Thanks for reply.
Posting Permissions
LinkBack URL
About LinkBacks
