Results 1 to 1 of 1

Thread: Servo Dynamics Drive board needed

  1. 09-01-2010, 11:09 AM #1
    TowerCNC
    TowerCNC is offline
    Registered
    Join Date
    Jul 2008
    Location
    USA
    Posts
    13
    Downloads
    0
    Uploads
    0

    Servo Dynamics Drive board needed

    Looking for a SD 1525-10 drive board. I believe my X axis drive board went south and I am looking for a cost effective direct replacement. I may have this one rebuilt depending on what kind of feedback I get here. My control is a Dynapath Delta 20 and I had even toyed around with the notion of adding the 4th axis if I can source a few drive boards on the cheap. Please let me know what you have. I would like to get my machine back up and turning! Thanks.
    Last edited by TowerCNC; 09-03-2010 at 02:29 AM.

« NEC Spindle Drive ADU75FP1L | Servodrive Mitsubishi MR-S1-80E01 »

Similar Threads

  1. MaxAx 200 Servo Drive Needed
    By Stickerman in forum Want To Buy...Need help!
    Replies: 3
    Last Post: 03-01-2012, 10:54 AM
  2. Need Help!- Project! Haas Vector Drive replacement, MOCON board / Brushless Servo Amp interface
    By marvinmfg in forum Haas Mills
    Replies: 12
    Last Post: 07-10-2010, 10:04 PM
  3. Need msi servo drive board
    By 1933ford in forum Tree
    Replies: 6
    Last Post: 01-08-2009, 09:47 PM
  4. Need help on Servo Dynamics board SDFP1525-17
    By Twil759 in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 0
    Last Post: 11-28-2007, 12:33 PM
  5. Cheap 0 Clifton and servo drive selection (advice needed)
    By Konstantin in forum General Electronics Discussion
    Replies: 4
    Last Post: 04-14-2004, 11:21 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.