VM Basic Demo - CNCzone.com-The Largest Machinist Community on the net!

SamLS · #1 10-28-2004, 12:12 PM

Is there any way to specify no machine zones around a part in this software. I don't want the cutter to go more than its diameter around the side of the part when profiling. Can I import in a custom stock size the is not square and have the software not profile all the stock. How would you work around clamps etc. Thanks

RandMan · #2 10-28-2004, 11:40 PM

They refer to that as regions. Check out the machining regions section of the help file and they explain them fairly well. Kinda funky but they work.

DareBee · #3 10-29-2004, 08:01 AM

It would be different for both 2.5 or 3d. Which are you asking about?

SamLS · #4 10-29-2004, 08:36 AM

I'm working with 3d.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
newbie Quest. Basic Static Load on Linear Bearing Block kNewton ?	Calico	Linear and Rotary Motion	4	06-27-2007 07:10 PM
OneCNC XR Online Demo	JavaDog	OneCNC	8	08-11-2005 11:25 PM
CAD CAM Demo strategy questions?	Idle hands	General CAM Discussion	6	05-24-2005 02:45 PM
Demo?	DAB_Design	CamSoft Products	11	04-11-2005 12:09 PM
V19 Demo Problems & Questions.	SamLS	BobCad-Cam	0	10-28-2004 12:03 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)