Can`t edit tools, speeds and feeds etc - CNCzone.com-The Largest Machinist Community on the net!

RaveBoy10 · #1 05-18-2008, 05:13 PM

Hi All
I just installed VM 5.09 with the lastest service packs. I tried a small project but when I go to select parameters, or tooling, or speeds and feeds nothing comes up. I tried double -clicking on the icon but still no luck. I also
reinstalled the application but still I can`t select and edit those project settings.

Thanks

DareBee · #2 05-20-2008, 12:11 PM

Try support"at"mecsoft"dot"com or give them a phone call.

Sounds like a bad install.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Speeds and Feeds	frogger	Haas Mills	20	02-26-2008 03:42 PM
Need Help!- speeds and feeds	rodzilla	Benchtop Machines	3	02-19-2008 11:30 PM
What Speeds, feeds and tools	Thai CNC	WoodWorking	5	12-20-2006 01:22 AM
feeds speeds and cutting tools	replicapro	General Metalwork Discussion	4	09-14-2004 01:22 PM
feeds and speeds	Mortek	Hard and High Speed Machining	6	02-28-2004 04:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)